Band Heater


Type | B


STOCK DESIGN:
3” nominal Fiberglass sleeved leadwires exit same side each end of heater.

View Our Band & Strip Heater Catalogue | Click Here


Rama uses extra strength full band clamps, the standard, low-profile design utilizes a 22-gauge stainless steel with continuous strap and spot-welded turnover. These provide full strength clamping with minimum heat distortion. In addition, Rama also provides a 90° facing clamp, which is an integral part of the heater sheath, and the pin-and-screw clamp, which is spot-welded to the heater sheath and does not require a clamping band. These latter two designs are available upon request. All standard design and stock heaters are supplied with the standard full clamp band.

  • Enter two known values and press Solve to calculate unknowns.

    Volts
    (Volts)

    Resistance
    (Ohms)

    Current
    (Amps)

    Power
    (Watts)