Band Heater Quote Form

Please fill out our quote form as complete as possible to eliminate confusion and delayed response from our customer support team.

INQUIRY DATE :
QTY:
COMPANY:
CONTACT NAME:
ADDRESS:
City
STATE:
ZIP:
Phone
Email
SPECIFICATIONS:
INNER DIAMETER:

(OUTER DIAMETER OF PART HEATER IS TO GO ON)
WIDTH:

(LENGTH OF THE AREA ON THE PART HEATER IS TO COVER)
WATTS:
VOLTS:
PHASE:
- SINGLE
- 3-PHASE (WYE ONLY)
- DUAL
ENTER HIGH VOLTAGE
ENTER LOW VOLTAGE
OPERATING TEMPERATURE(°F)

(IF NOT GIVEN WE WILL DESIGN FOR VALUES BEING AT STARTUP TEMPERATURES OF 68°F)
CONFIGURATION:
LEAD TYPE:
- TYPE ‘A’
- TYPE ‘B’
- TYPE ‘C’
- TYPE ‘D’
- TYPE ‘E’
- TYPE ‘F
- ’ TYPE ‘G’
- TYPE ‘H’
- TYPE ‘J’
IF CHOOSING LEADWIRE, PROVIDE FINISHED LENGTH (+2%):
POST TERMINALS:
- TYPE ‘K’
- TYPE ‘L’
- TYPE ‘M’
DESIGN FEATURES:
SHEATH MATERIAL:
- ALUMINIZED STEEL (STANDARD)
- STAINLESS STEEL
ENTER GAP SIZE
MODIFICATION:
- BENDABLE
- TWO PIECE
ENTER VOLTAGES FOR EACH HALF
CLAMP:
- STRAP
- 90° FACING
- PIN & SCREW
TEMPERATURE CONTROL:
- THERMOCOUPLE
- THERMOSTAT
A DRAWING MUST BE SUBMITED FOR SPECIAL HOLES, CUTOUTS, UNUSUAL SHAPES, THERMOSTAT PLACEMENT, THERMOCOUPLE PLACEMENT, ETC. CONSULT FACTORY FOR STRIP HEATERS OVER 45” LONG OR 12” WIDE.
A DRAWING MUST BE SUBMITED FOR SPECIAL HOLES, CUTOUTS, UNUSUAL SHAPES, THERMOSTAT PLACEMENT, THERMOCOUPLE PLACEMENT, ETC. CONSULT FACTORY FOR STRIP HEATERS OVER 45” LONG OR 12” WIDE.
NOTE ANY SPECIAL REQUIREMENTS BELOW:
CAPTCHA

INQUIRY DATE:

COMPANY:

CONTACT NAME:

ADDRESS:

CITY:

STATE:

ZIP:

PHONE:

FAX:

EMAIL:

SPECIFICATIONS:

INNER DIAMETER:

WIDTH:

WATTS:

VOLTS:

PHASE:

SINGLE 3-PHASE (WYE ONLY) DUAL

ENTER HIGH VOLTAGE:

ENTER LOW VOLTAGE:

OPERATING TEMPERATURE (°F)

CONFIGURATION:

LEAD TYPE:
3-PHASE 2-ZONE 3-ZONE

IF CHOOSING LEADWIRE, PROVIDE FINISHED LENGTH (+2%):

Post Terminals:
TYPE ‘K’ TYPE ‘L’ TYPE ‘M’

DESIGN FEATURES:
SHEATH MATERIAL:
ALUMINIZED STEEL (STANDARD) STAINLESS STEEL

ENTER GAP SIZE:

MODIFICATION:
SHEATH MATERIAL:
BENDABLE TWO PIECE

ENTER VOLTAGES FOR EACH HALF

CLAMP:

STRAP 90° FACING PIN & SCREW

TEMPERATURE CONTROL:

THERMOCOUPLE THERMOSTAT

A DRAWING MUST BE SUBMITED FOR SPECIAL HOLES, CUTOUTS, UNUSUAL SHAPES, THERMOSTAT PLACEMENT, THERMOCOUPLE PLACEMENT, ETC. CONSULT FACTORY FOR STRIP HEATERS OVER 45” LONG OR 12” WIDE.

RAMA COrporation

Home

Products

About Us

Contact

951-654-7351

Mon - Fri (6AM - 3PM)

Sat - Sun (Closed)

600 West Esplanade Ave,
San Jacinto CA, 92583

Facebook-f Instagram

Copyright © 2023 Rama Corporation. Designed by Fluent Designs