Band Heater Type B
$18.00 – $32.00
STOCK DESIGN:
3” nominal Fiberglass sleeved leadwires exit same side each end of heater.
- Description
- Additional information
Description
Rama uses extra strength full band clamps, the standard, low-profile design utilizes a 22-gauge stainless steel with continuous strap and spot-welded turnover. These provide full strength clamping with minimum heat distortion. In addition, Rama also provides a 90° facing clamp, which is an integral part of the heater sheath, and the pin-and-screw clamp, which is spot-welded to the heater sheath and does not require a clamping band. These latter two designs are available upon request. All standard design and stock heaters are supplied with the standard full clamp band.
Additional information
| Inner Diameter | 1, 1-1/4, 1-1/2, 1-3/4, 1-3/8, 2, 2-1/2, 2-1/4, 2-3/8, 3, 3-1/2, 3-3/4, 4 |
|---|---|
| Width | 3/4, 7/8, 1, 1-1/2, 1-1/4, 1-1/2, 2, 2-1/2, 2-1/4, 2-3/4, 3, 3-1/2, 4, 5 |
| Watts | 95, 100, 110, 115, 120, 150, 175, 200, 250, 275, 300, 350, 375, 400, 415, 440, 450, 500, 525, 550, 600, 650, 700, 750 |
| Volts | 120, 220, 240 |
| Lead Length | 12" LDS, 24" LDS, 36"LDS, 40" LDS |
