Band Heater Type B

0 out of 5

$18.00 – $32.00

STOCK DESIGN:
3” nominal Fiberglass sleeved leadwires exit same side each end of heater.

View Our Band & Strip Heater Catalogue | Click Here

SKU: 16B10B/DWT12-1 Category: Band & Strip Heaters

Inner Diameter
Width
Watts
Volts
Lead Length	Clear

Description
Additional information

Description

Rama uses extra strength full band clamps, the standard, low-profile design utilizes a 22-gauge stainless steel with continuous strap and spot-welded turnover. These provide full strength clamping with minimum heat distortion. In addition, Rama also provides a 90° facing clamp, which is an integral part of the heater sheath, and the pin-and-screw clamp, which is spot-welded to the heater sheath and does not require a clamping band. These latter two designs are available upon request. All standard design and stock heaters are supplied with the standard full clamp band.

Additional information

Inner Diameter	1, 1-1/4, 1-1/2, 1-3/4, 1-3/8, 2, 2-1/2, 2-1/4, 2-3/8, 3, 3-1/2, 3-3/4, 4
Width	3/4, 7/8, 1, 1-1/2, 1-1/4, 1-1/2, 2, 2-1/2, 2-1/4, 2-3/4, 3, 3-1/2, 4, 5
Watts	95, 100, 110, 115, 120, 150, 175, 200, 250, 275, 300, 350, 375, 400, 415, 440, 450, 500, 525, 550, 600, 650, 700, 750
Volts	120, 220, 240
Lead Length	12" LDS, 24" LDS, 36"LDS, 40" LDS