Band Heater Type | A

0 out of 5

3” nominal fiberglass sleeved leadwires, exit same side each end of heater.

View Our Band & Strip Heater Catalogue | Click Here


Rama uses extra strength full band clamps, the standard, low-profile design utilizes a 22-gauge stainless steel with continuous strap and spot-welded turnover. These provide full strength clamping with minimum heat distortion. In addition, Rama also provides a 90° facing clamp, which is an integral part of the heater sheath, and the pin-and-screw clamp, which is spot-welded to the heater sheath and does not require a clamping band. These latter two designs are available upon request. All standard design and stock heaters are supplied with the standard full clamp band.